Just like clock work...

We received a snow storm on December 19th that dropped roughly 6-8 inches of fresh powder.  There was not a lot of moisture in the snow due to the low temperatures that night/morning (-8 degrees.)  The snow stayed in place all day but I knew the wind would pick up at night because the next day was suppose to be sunny and a high of 35 degrees.  Like clock work, when I drove into work I could see the blowing snow, drifts forming and the wind swept turf.  The wind blew till about 11am that morning with some gusts reaching over 26mph. 
The snow fence we had up did its job! The fence broke up the wind pattern and allowed snow drifts to form, insulating the turf.

  The fence on #1 green

The fence on #18 Black Tee.  See how the snow is gone from the left (west) side of the fence.  The wind is blowing from the west, the fence is disrupting the flow, allowing the snow to deposit on the tee surface.  If the fence was not there, the tee surface would have been wind swept.

The fence on #2 fairway.  We only had the left side up before the storm.  The entire fairway would have been wind swept if not for the fence.  We added the other 2 rows yesterday in preparation of the upcoming Christmas Day snow storm.  There is 1/4 mile of snow fence up on this hole alone! 

The tree limbs are working perfectly!  I think we need to add more limbs to the west side to catch more snow.  The snow drift length will range from 10-30 feet long.  Good lesson here on the placement of the limbs for the next time we use this method.

 

 

I would like to wish everyone a Merry Christmas and Happy New Year!  Thank you for all the support here at Arrowhead Golf Club.  I look forward to another successful year in 2017! 



 



Prepping the course for bed

There is a lot of work to be done when you are preparing to "putting the course to bed" for the winter.  Timing is everything! There are many steps to accomplish just the simplest of tasks.  Before any snow flies, we mark all the green, tee and and mainline valves throughout the course.  We do this because you never know if you need to fire up the irrigation system mid winter to apply some needed water.  Have you ever looked for a valve under snow?  It is like finding a needle in a hay stack.
Our first major task is applying all the fungicide and anti-desiccants to the greens, tees and fairways.  You have to make sure you get great contact to all surfaces of the plant blade, so all surfaces must be clean of debris such as leaves, sticks and pine needles.   This task can take up to several days to accomplish due to the nightly wind.
The seconds step is very labor intensive as we will install snow fence around the course.  We strategically place fence on the course to capture the blowing snow.  Due to the nightly wind, any snow we get has a great potential of blowing off the surface.  The snow fence will disrupt the wind to allow the snow to pile up and form snow drifts.  These snow drifts keeps the turf covered to help prevent the grass from drying out (winter dessication.)

This year after taking classes at our local turf show and conference, I learned another approach to snow fence.  We always do a lot of tree work in off-season, so why not use tree branches as snow fence.  We tried this approach on the #6 forward tee.  Lets see if it works.

At some point when the weather forecast looks like it will be cold for a extended time, we will prepare the irrigation system to be blown out with compressed air.  The day prior to blowout, we will drive around the course and close all the air relief valves.  The valves play an important role with the function of the system.  When we are pressurized up during the warmer months, these valves will allow air to move out of the system while keeping in the water.  During blowout, we close the valves to make sure no air leaves the system.  We also manually drain the system of water through quick couplers.  During the blowout, 3 of us will be on the course to operating the satellite boxes and one of us at the pump house making sure we do not get to high on pressure.  Air can compress more than water so we like to blow out at 1/4 to 1/2 of the working pressure (about 30-55psi.) 

No matter what we do sometimes damage and turf loss occurs.  We try to be as preventative as possible, but sometimes you never know what mother nature will give you. 

 

This damage from the antlers of the mule deer will be repaired in the spring.  Got to love our wildlife!